Mimolite wiring diagram for apollo gate opener.
Mimolite garage door smartthings.
Smartthings say the device handler is not supported.
I have a set up a mimolite to open and close a garage door.
Device handler for mimolite loading branch information.
Mb323 i wish i would have seen this thread earlier because i wrote one a long time ago that i ve been using that i could have shared it uses the magnetic contact similar to post 3 above and it also notifies if when the mimolite looses power.
I would like to use a mimolite to open close and provide the status of a garage door via smartthings.
Make future change here.
In the routine.
Does anyone have the actual device code for the mimolite garage door controller.
Fortrezz say the hardware is goo it is a device handler problem.
I don t know if this is linked to current reports.
The mimolite garage door device type will allow me to open and control the garage door in the things section although the state is not correct and the configure button does nothing.
If i go to the ide and add a device by selecting from template and then select mimolite garage door controller the code doesn t load or show up like other devices.
Mimolite installation guide for smartthings.
Got stuck between the two and finally gave up and returned the product.
Mimolite wiring diagram for garage door application.
Mimolite installation instructions for vera controllers.
Based on todd wackford s mimolite garage door opener metadata automatically generated.
See mimolite for garage door and magnetic door contact this worked find except sometimes the close open event would get missed.
I have added this device handler to my ide.
The mimolite module is an interface bridge module capable of converting a digital or analog voltage input and or a z wavetm rf message input to a dry contact relay output and or a z wavetm rf message output.
Flow meter guide with smartthings.
Connect one wired devices.
Mimo2 installation instructions.
Next i set up a routine to turn on the garage light and open the garage door.
Contribute to fortrezz smartthings development by creating an account on github.
In the things menu i can read the current door status as well as open and close the door.
The tile in my device type actuates the mimolite to open close the door but it doesn t reflect the state of the door so i created a virtual.
Mimolite comes in a plastic enclosure for indoor use only.
In doors and locks i can get it to show me the correct state i m just using a smartthings open close sensor however tapping the button does nothing.
So far this is what i ve done.
I have mimolite garage door controller set as the device type.
Had issues with it reporting wrong garage door status on the phone app.
The mimolite is not supported by smartthings.
So i was hoping to change the icons and.
Dantheman2865 committed nov 2.
Initially i got the solution that johnconstantelo developed working with a magnetic switch that triggered when the door closed.
I have a regular sears door opener with a button that either opens or closes the door.
